Compare Quotes & Save up to 33%

Compare Quotes & Save up to 33%

Get up to 3 quotes from pros in your postcode

1. Do you require a local plumber?*

Powered by Bark.com

Underfloor Heating Cost 2026: Wet vs Electric, 6 Prices Compared

Underfloor heating typically costs £50 to £100 per square metre for an electric system and £80 to £150 per square metre for a wet (water) system, supplied and fitted. For a single bathroom, an electric mat might cost £400 to £900 in total. A wet system across a whole ground floor can run to £5,000 to £10,000 or more, depending on how much floor needs lifting.

Teal graphic with a house outline and the words Underfloor Heating Cost Wet vs Electric Prices Compared

This guide compares the two systems, sets out typical prices and shows what they cost to run at today's energy prices.

Comparing Quotes Could Save Up To 33%:

→ Click To Get Quotes

Electric vs Wet Underfloor Heating

Feature Electric Wet
Typical install cost £50 to £100 per m² £80 to £150 per m²
Running cost Higher Lower
Best for Single rooms, retrofits Extensions, new builds, whole floors
Floor height increase Very small Can be larger
Disruption Low Higher

Typical UK ranges, checked October 2026.

6 Typical Prices

Job Typical cost
Electric mat in a small bathroom (4m²) £400 to £900
Electric system in a kitchen (15m²) £1,000 to £2,000
Wet system in an extension (20m²) £2,000 to £3,500
Wet system retrofit to a ground floor (50m²) £5,000 to £10,000
Thermostat and controls £100 to £300 per zone
Insulation boards £10 to £25 per m²

Typical UK ranges from installer quotes and published cost guides, checked October 2026.

Running Costs

Running costs depend on your energy prices, insulation and how you use the system. Under the Ofgem price cap for October to December 2026, electricity is around 26.32p per kWh and gas around 7.97p per kWh.

Electric underfloor heating converts electricity straight into heat, so a 150 watt per m² mat in a 4m² bathroom draws 0.6kW. Running it for two hours a day uses 1.2kWh, about 32p a day at the cap rate.

A wet system connected to a gas boiler or heat pump costs far less per unit of heat, which is why it's the better choice for large areas. It pairs especially well with a heat pump, because it runs at low water temperatures. See our heat pump cost guide.

What Affects The Price

  • Floor type: tiles and stone conduct heat well. Thick carpet doesn't.
  • Screed: wet systems in new floors are usually laid in screed, which adds cost and drying time.
  • Retrofit: lifting existing floors is the biggest cost driver.
  • Insulation: boards under the system stop heat going into the ground.
  • Controls: smart thermostats cost more but help control running costs.
  • Manifold: wet systems need a manifold and pump, often £400 to £900.

Is Underfloor Heating Worth It?

It's comfortable, frees up wall space and spreads heat evenly. In a bathroom or kitchen with tiled floors, an electric mat is a cheap luxury. For extensions and new builds, wet underfloor heating is often the most efficient way to heat the space.

It's less suited to retrofitting upstairs rooms with timber floors and carpets, where radiators remain cheaper and simpler.

Underfloor Heating vs Radiators

Factor Underfloor heating Radiators
Install cost Higher Lower
Comfort Even, gentle heat Hot spots near radiators
Heat up time Slower Faster
Wall space Frees up walls Takes up walls
Efficiency with a heat pump Very good Good with larger radiators

If you're thinking of moving radiators rather than replacing them, see move radiators.

Ways To Save

  • Fit underfloor heating when you're already replacing the floor.
  • Use electric mats only in small rooms.
  • Insulate well under the system.
  • Use zoned controls so you only heat rooms in use.

How Long Does Installation Take?

An electric mat in a bathroom can usually be laid in a day, with tiling the following day once the adhesive has set. A wet system takes longer. In an extension, the pipes are laid over insulation and covered with screed, which then needs time to dry before you can lay the final floor. Traditional sand and cement screed can take several weeks to dry fully, while liquid screeds are often faster. Retrofitting a wet system to an existing ground floor usually takes several days, plus time for floor finishes.

Choosing The Right Floor Finish

Stone and ceramic tiles are the best partners for underfloor heating because they pass heat quickly into the room. Engineered wood and luxury vinyl work well too, as long as they're rated for underfloor heating. Carpet can work, but keep the combined tog value of the carpet and underlay low, or the heat struggles to get through.

FAQs

How much does electric underfloor heating cost to run?

Roughly 30p to 40p a day for a small bathroom used two hours a day at current cap rates.

Can underfloor heating go under laminate?

Yes, many systems are compatible with laminate and engineered wood. Check the flooring maker's limits.

How long does wet underfloor heating last?

The pipes often last 50 years or more. Pumps and controls need replacing sooner.

Does underfloor heating need a plumber?

Wet systems need a plumber or heating engineer. Electric systems need an electrician for the final connection.

Get Quotes

Use the form at the top of this page to get quotes from local plumbers and heating engineers. Tell them the room size, floor type and your current heating system.

Checked October 2026. Prices are typical UK ranges and will vary by area and installer.