Compare Quotes & Save up to 33%

Compare Quotes & Save up to 33%

Get up to 3 quotes from pros in your postcode

1. Do you require a local plumber?*

Powered by Bark.com

Dishwasher Not Draining? 7 Fixes To Try In 2026

If your dishwasher isn't draining, the most likely cause is a blocked filter. Food, labels and bits of glass collect in the filter at the bottom of the machine and stop water escaping. Clearing it takes five minutes. If that doesn't work, the problem is usually in the drain hose, the sink waste or the drain pump.

Teal graphic with a house outline and the words Dishwasher Not Draining Seven Fixes To Try

Work through these seven fixes in order. Most people solve the problem by step three.

Comparing Quotes Could Save Up To 33%:

→ Click To Get Quotes

Before You Start

  • Turn the dishwasher off at the wall.
  • Put towels on the floor.
  • Bail out standing water with a cup and sponge.

Quick Guide

Where to check What to look for Difficulty
Filter Food, grease, broken glass Easy
Sump below the filter Debris or labels Easy
Sink trap and waste Blockage or grease Easy to moderate
Drain hose Kinks or blockage Moderate
Air gap or spigot Blanking cap left in Moderate
Drain pump Obstruction or failure Harder
Control or sensor fault Error code Engineer

1. Clean The Filter

Remove the bottom basket. Twist the filter anticlockwise and lift it out. Rinse it under the hot tap and scrub with an old toothbrush. Check the area underneath for debris. Refit it firmly, as a loose filter can cause problems of its own.

Do this every few weeks to prevent the issue coming back.

2. Check The Sump

With the filter out, look into the sump with a torch. You may find a cherry stone, a bit of glass or a label. Remove anything you can reach, carefully.

3. Clear The Sink Waste

Most dishwashers drain into the sink waste. If the sink is slow to drain, the dishwasher will struggle too. Unscrew the trap under the sink, with a bowl beneath it, and clear any grease. Our drain unblocking guide covers stubborn blockages.

4. Check The New Spigot

If the dishwasher has just been fitted or the sink waste replaced, check that the blanking cap was removed from the dishwasher spigot on the waste. This is a very common mistake after new installs.

5. Inspect The Drain Hose

Pull the dishwasher out carefully. Look for kinks in the grey drain hose and make sure it loops up higher than the waste connection to stop backflow. Disconnect the hose and flush it through with water. Check the hose isn't crushed against the wall.

6. Check The Drain Pump

The pump sits under the sump. On many models you can remove a small cover inside the sump to reach the impeller. Turn it gently with your finger. If it's stuck, remove what's blocking it. If it turns freely but you hear humming and no draining, the pump may have failed.

7. Look Up The Error Code

Many machines display a code when draining fails. Look it up in your manual. If it points to a sensor or control board fault, call an engineer.

Typical Repair Costs

Repair Typical cost
Engineer call out £60 to £100
Drain pump replacement £100 to £180
Drain hose replacement £60 to £120
Sink waste unblocking by a plumber £60 to £120
New integrated dishwasher fitted £350 to £800

Typical UK ranges, checked October 2026.

Repair Or Replace?

If your dishwasher is under seven years old, a pump or hose repair is usually worth it. If it's older and needs a control board or more than one part, compare the cost with a new energy efficient model. Our white goods and appliance running costs guides help with the sums.

How To Stop It Happening Again

  • Scrape plates before loading.
  • Clean the filter every two to four weeks.
  • Run a hot cleaning cycle once a month.
  • Use dishwasher salt and rinse aid as recommended. See salt in a dishwasher.
  • Run the kitchen tap until hot before starting a cycle.

Is It Safe To Use Until Fixed?

It's best not to. Standing water can smell and grow bacteria, and a machine that can't drain may leak or trip its safety cut out. Wash up by hand until you've found the fault. If water is leaking onto the floor, switch off at the wall and turn off the supply valve under the sink.

Common Mistakes

People often reach for drain unblocker first. Strong chemicals can damage the seals and hoses inside a dishwasher, so avoid pouring them into the machine. Another common mistake is pushing the machine back too hard after checking it, which kinks the drain hose again. Slide it in gently and check the hose before you refit any plinth.

FAQs

Why is there water in the bottom of my dishwasher?

Usually a blocked filter, sump or sink waste. Clean the filter first.

Can I use bicarbonate of soda and vinegar?

They can help with odours and light grease, but won't clear solid blockages.

Is a small amount of water normal?

A little water around the sump is normal on some models. A pool of standing water isn't.

Should I call a plumber or an appliance engineer?

A plumber for sink and waste blockages. An appliance engineer for pumps and electrics.

Need Help?

Use the form at the top of this page to find a local plumber.

Checked October 2026. Costs are typical UK ranges.